The proposed scheme employs novel signal design for simultaneous wireless information and power transfer system
BUSAN, South Korea, Dec. 1, 2022 /PRNewswire/ — Simultaneous wireless information and power transfer (SWIPT) is a promising technology to connect and energize low-power devices wirelessly over a long distance. The radio frequency-based technique would thus enable the Internet of Things in the future. However, state-of-the-art low-power SWIPT receivers still consume much more energy for communication than the amount they can harvest, which hinders further development and growth of the Internet-of-Things (IoT) ecosystem.
The current literature highlights two common receiver architectures based on time-switching and power-splitting schemes. While these designs can be implemented using conventional energy and information modules, they do not tap the potential benefits of an integrated system. Therefore, researchers have also suggested an integrated receiver architecture (IntRx).
Recently, Dr. Junghoon Kim of the Korea Maritime and Ocean University and his colleague, have proposed a novel signal design for SWIPT with IntRx architecture. “Our motivation was to design a suitable signal to be used in an integrated type receiver for the SWIPT system. The signal can bring information and power together and be decoded and harvested by a single integrated type receiver,” explains Dr. Kim.
How does their system work? To begin with, they modified a conventional pulse position modulation scheme (M-PPM) to make it suitable for SWIPT IntRx. It encodes information on the pulse position and transmits high-amplitude pulses for short periods. Consequently, the high peak-to-average-power ratio of this new signal leads to higher harvesting power at the receiver compared to the conventional signals, which continuously deliver the same level of average power. This improvement is based on a higher instantaneous power conversion (RF to DC) efficiency owing to the high peak-to-average power ratio (PAPR) signal design that takes advantage of the nonlinearity of the energy harvester’s rectifier. Simultaneously, the receiver can extract the information from the rectified signal by finding the position of the pulse in a specific duration. Therefore, the non-coherent modulation method allows decoding without power-consuming radio frequency components such as low noise amplifier (LNA) and mixer, making it suitable for low-power IntRx SWIPT systems.
The findings of their study were made available online on 15th December 2021 and published in Volume 9, Issue 14 of IEEE Internet of Things Journal on 15th July 2022.
The team also implemented a SWIPT testbed in an indoor environment and verified the benefit of their new signal design in a real-world setting. The experiments showed the IntRx system and PPM signal pair to have more than 200% gain over conventional methods in WPT perspective. Also, the experiment confirmed that a low-power consuming information decoding scheme works well in reality. Moreover, the findings were consistent with theoretical and numerical calculations.
To sum up, the comprehensive research confirms the feasibility and outstanding performance of the new modulation method, which can improve power transfer efficiency and reduce power consumption for information decoding. Dr. Kim reiterates, “Our technique will lead to small battery-less devices with low power consumption and small form factor. It shall catalyze the explosive growth of the Internet of Things ecosystem.”
Title of original paper: Wireless Information and Power Transfer for IoT: Pulse Position Modulation, Integrated Receiver, and Experimental Validation
Journal: IEEE Internet of Things Journal
*Corresponding author’s email: firstname.lastname@example.org
+82 51 410 4712
SOURCE National Korea Maritime & Ocean University